About Kernel Documentation Linux Kernel Contact Linux Resources Linux Blog

Documentation / devicetree / bindings / ata / tegra-sata.txt


Based on kernel version 4.6.2. Page generated on 2016-06-08 13:02 EST.

1	Tegra124 SoC SATA AHCI controller
2	
3	Required properties :
4	- compatible : For Tegra124, must contain "nvidia,tegra124-ahci".  Otherwise,
5	  must contain '"nvidia,<chip>-ahci", "nvidia,tegra124-ahci"', where <chip>
6	  is tegra132.
7	- reg : Should contain 2 entries:
8	  - AHCI register set (SATA BAR5)
9	  - SATA register set
10	- interrupts : Defines the interrupt used by SATA
11	- clocks : Must contain an entry for each entry in clock-names.
12	  See ../clocks/clock-bindings.txt for details.
13	- clock-names : Must include the following entries:
14	  - sata
15	  - sata-oob
16	  - cml1
17	  - pll_e
18	- resets : Must contain an entry for each entry in reset-names.
19	  See ../reset/reset.txt for details.
20	- reset-names : Must include the following entries:
21	  - sata
22	  - sata-oob
23	  - sata-cold
24	- phys : Must contain an entry for each entry in phy-names.
25	  See ../phy/phy-bindings.txt for details.
26	- phy-names : Must include the following entries:
27	  - sata-phy : XUSB PADCTL SATA PHY
28	- hvdd-supply : Defines the SATA HVDD regulator
29	- vddio-supply : Defines the SATA VDDIO regulator
30	- avdd-supply : Defines the SATA AVDD regulator
31	- target-5v-supply : Defines the SATA 5V power regulator
32	- target-12v-supply : Defines the SATA 12V power regulator
Hide Line Numbers


About Kernel Documentation Linux Kernel Contact Linux Resources Linux Blog