About Kernel Documentation Linux Kernel Contact Linux Resources Linux Blog

Documentation / devicetree / bindings / mtd / m25p80.txt


Based on kernel version 4.0. Page generated on 2015-04-14 21:21 EST.

1	* MTD SPI driver for ST M25Pxx (and similar) serial flash chips
2	
3	Required properties:
4	- #address-cells, #size-cells : Must be present if the device has sub-nodes
5	  representing partitions.
6	- compatible : Should be the manufacturer and the name of the chip. Bear in mind
7	               the DT binding is not Linux-only, but in case of Linux, see the
8	               "spi_nor_ids" table in drivers/mtd/spi-nor/spi-nor.c for the list
9	               of supported chips.
10	- reg : Chip-Select number
11	- spi-max-frequency : Maximum frequency of the SPI bus the chip can operate at
12	
13	Optional properties:
14	- m25p,fast-read : Use the "fast read" opcode to read data from the chip instead
15	                   of the usual "read" opcode. This opcode is not supported by
16	                   all chips and support for it can not be detected at runtime.
17	                   Refer to your chips' datasheet to check if this is supported
18	                   by your chip.
19	
20	Example:
21	
22		flash: m25p80@0 {
23			#address-cells = <1>;
24			#size-cells = <1>;
25			compatible = "spansion,m25p80";
26			reg = <0>;
27			spi-max-frequency = <40000000>;
28			m25p,fast-read;
29		};
Hide Line Numbers


About Kernel Documentation Linux Kernel Contact Linux Resources Linux Blog