Documentation / devicetree / bindings / media / i2c / ov2659.txt


Based on kernel version 6.8. Page generated on 2024-03-11 21:26 EST.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47
* OV2659 1/5-Inch 2Mp SOC Camera

The Omnivision OV2659 is a 1/5-inch SOC camera, with an active array size of
1632H x 1212V. It is programmable through a SCCB. The OV2659 sensor supports
multiple resolutions output, such as UXGA, SVGA, 720p. It also can support
YUV422, RGB565/555 or raw RGB output formats.

Required Properties:
- compatible: Must be "ovti,ov2659"
- reg: I2C slave address
- clocks: reference to the xvclk input clock.
- clock-names: should be "xvclk".
- link-frequencies: target pixel clock frequency.

Optional Properties:
- powerdown-gpios: reference to the GPIO connected to the pwdn pin, if any.
  Active high with internal pull down resistor.
- reset-gpios: reference to the GPIO connected to the resetb pin, if any.
  Active low with internal pull up resistor.

For further reading on port node refer to
Documentation/devicetree/bindings/media/video-interfaces.txt.

Example:

	i2c0@1c22000 {
		...
		...
		 ov2659@30 {
			compatible = "ovti,ov2659";
			reg = <0x30>;

			clocks = <&clk_ov2659 0>;
			clock-names = "xvclk";

			powerdown-gpios = <&gpio6 14 GPIO_ACTIVE_HIGH>;
			reset-gpios = <&gpio6 15 GPIO_ACTIVE_LOW>;

			port {
				ov2659_0: endpoint {
					remote-endpoint = <&vpfe_ep>;
					link-frequencies = /bits/ 64 <70000000>;
				};
			};
		};
		...
	};