Documentation / devicetree / bindings / sound / rt5665.txt


Based on kernel version 6.8. Page generated on 2024-03-11 21:26 EST.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68
RT5665/RT5666 audio CODEC

This device supports I2C only.

Required properties:

- compatible : One of "realtek,rt5665", "realtek,rt5666".

- reg : The I2C address of the device.

- interrupts : The CODEC's interrupt output.

Optional properties:

- realtek,in1-differential
- realtek,in2-differential
- realtek,in3-differential
- realtek,in4-differential
  Boolean. Indicate MIC1/2/3/4 input are differential, rather than single-ended.

- realtek,dmic1-data-pin
  0: dmic1 is not used
  1: using GPIO4 pin as dmic1 data pin
  2: using IN2N pin as dmic2 data pin

- realtek,dmic2-data-pin
  0: dmic2 is not used
  1: using GPIO5 pin as dmic2 data pin
  2: using IN2P pin as dmic2 data pin

- realtek,jd-src
  0: No JD is used
  1: using JD1 as JD source

- realtek,ldo1-en-gpios : The GPIO that controls the CODEC's LDO1_EN pin.

Pins on the device (for linking into audio routes) for RT5659/RT5658:

  * DMIC L1
  * DMIC R1
  * DMIC L2
  * DMIC R2
  * IN1P
  * IN1N
  * IN2P
  * IN2N
  * IN3P
  * IN3N
  * IN4P
  * IN4N
  * HPOL
  * HPOR
  * LOUTL
  * LOUTR
  * MONOOUT
  * PDML
  * PDMR

Example:

rt5659 {
	compatible = "realtek,rt5665";
	reg = <0x1b>;
	interrupt-parent = <&gpio>;
	interrupts = <TEGRA_GPIO(W, 3) IRQ_TYPE_LEVEL_HIGH>;
	realtek,ldo1-en-gpios =
		<&gpio TEGRA_GPIO(V, 3) GPIO_ACTIVE_HIGH>;
};