Based on kernel version 4.13.3. Page generated on 2017-09-23 13:55 EST.
1 The driver for the HFC-PCI and HFC-PCI-A chips from CCD may be used 2 for many OEM cards using this chips. 3 Additionally the driver has a special feature which makes it possible 4 to read the echo-channel of the isdn bus. So all frames in both directions 5 may be logged. 6 When the echo logging feature is used the number of available B-channels 7 for a HFC-PCI card is reduced to 1. Of course this is only relevant to 8 the card, not to the isdn line. 9 To activate the echo mode the following ioctls must be entered: 10 11 hisaxctrl <driver/cardname> 10 1 12 13 This reduces the available channels to 1. There must not be open connections 14 through this card when entering the command. 15 And then: 16 17 hisaxctrl <driver/cardname> 12 1 18 19 This enables the echo mode. If Hex logging is activated the isdnctrlx 20 devices show a output with a line beginning of HEX: for the providers 21 exchange and ECHO: for isdn devices sending to the provider. 22 23 If more than one HFC-PCI cards are installed, a specific card may be selected 24 at the hisax module load command line. Supply the load command with the desired 25 IO-address of the desired card. 26 Example: 27 There tree cards installed in your machine at IO-base addresses 0xd000, 0xd400 28 and 0xdc00 29 If you want to use the card at 0xd400 standalone you should supply the insmod 30 or depmod with type=35 io=0xd400. 31 If you want to use all three cards, but the order needs to be at 0xdc00,0xd400, 32 0xd000 you may give the parameters type=35,35,35 io=0xdc00,0xd400,0xd00 33 Then the desired card will be the initialised in the desired order. 34 If the io parameter is used the io addresses of all used cards should be 35 supplied else the parameter is assumed 0 and a auto search for a free card is 36 invoked which may not give the wanted result. 37 38 Comments and reports to firstname.lastname@example.org or email@example.com 39 40