About Kernel Documentation Linux Kernel Contact Linux Resources Linux Blog

Documentation / devicetree / bindings / i2c / i2c-st.txt




Custom Search

Based on kernel version 3.16. Page generated on 2014-08-06 21:37 EST.

1	ST SSC binding, for I2C mode operation
2	
3	Required properties :
4	- compatible : Must be "st,comms-ssc-i2c" or "st,comms-ssc4-i2c"
5	- reg : Offset and length of the register set for the device
6	- interrupts : the interrupt specifier
7	- clock-names: Must contain "ssc".
8	- clocks: Must contain an entry for each name in clock-names. See the common
9	  clock bindings.
10	- A pinctrl state named "default" must be defined to set pins in mode of
11	  operation for I2C transfer.
12	
13	Optional properties :
14	- clock-frequency : Desired I2C bus clock frequency in Hz. If not specified,
15	  the default 100 kHz frequency will be used. As only Normal and Fast modes
16	  are supported, possible values are 100000 and 400000.
17	- st,i2c-min-scl-pulse-width-us : The minimum valid SCL pulse width that is
18	  allowed through the deglitch circuit. In units of us.
19	- st,i2c-min-sda-pulse-width-us : The minimum valid SDA pulse width that is
20	  allowed through the deglitch circuit. In units of us.
21	- A pinctrl state named "idle" could be defined to set pins in idle state
22	  when I2C instance is not performing a transfer.
23	- A pinctrl state named "sleep" could be defined to set pins in sleep state
24	  when driver enters in suspend.
25	
26	
27	
28	Example :
29	
30	i2c0: i2c@fed40000 {
31		compatible	= "st,comms-ssc4-i2c";
32		reg		= <0xfed40000 0x110>;
33		interrupts	=  <GIC_SPI 187 IRQ_TYPE_LEVEL_HIGH>;
34		clocks		= <&CLK_S_ICN_REG_0>;
35		clock-names	= "ssc";
36		clock-frequency = <400000>;
37		pinctrl-names	= "default";
38		pinctrl-0	= <&pinctrl_i2c0_default>;
39		st,i2c-min-scl-pulse-width-us = <0>;
40		st,i2c-min-sda-pulse-width-us = <5>;
41	};
Hide Line Numbers
About Kernel Documentation Linux Kernel Contact Linux Resources Linux Blog

Information is copyright its respective author. All material is available from the Linux Kernel Source distributed under a GPL License. This page is provided as a free service by mjmwired.net.