About Kernel Documentation Linux Kernel Contact Linux Resources Linux Blog

Documentation / devicetree / bindings / media / samsung-s5k6a3.txt




Custom Search

Based on kernel version 3.16. Page generated on 2014-08-06 21:37 EST.

1	Samsung S5K6A3(YX) raw image sensor
2	---------------------------------
3	
4	S5K6A3(YX) is a raw image sensor with MIPI CSI-2 and CCP2 image data interfaces
5	and CCI (I2C compatible) control bus.
6	
7	Required properties:
8	
9	- compatible	: "samsung,s5k6a3";
10	- reg		: I2C slave address of the sensor;
11	- svdda-supply	: core voltage supply;
12	- svddio-supply	: I/O voltage supply;
13	- afvdd-supply	: AF (actuator) voltage supply;
14	- gpios		: specifier of a GPIO connected to the RESET pin;
15	- clocks	: should contain list of phandle and clock specifier pairs
16			  according to common clock bindings for the clocks described
17			  in the clock-names property;
18	- clock-names	: should contain "extclk" entry for the sensor's EXTCLK clock;
19	
20	Optional properties:
21	
22	- clock-frequency : the frequency at which the "extclk" clock should be
23			    configured to operate, in Hz; if this property is not
24			    specified default 24 MHz value will be used.
25	
26	The common video interfaces bindings (see video-interfaces.txt) should be
27	used to specify link to the image data receiver. The S5K6A3(YX) device
28	node should contain one 'port' child node with an 'endpoint' subnode.
29	
30	Following properties are valid for the endpoint node:
31	
32	- data-lanes : (optional) specifies MIPI CSI-2 data lanes as covered in
33	  video-interfaces.txt.  The sensor supports only one data lane.
Hide Line Numbers
About Kernel Documentation Linux Kernel Contact Linux Resources Linux Blog

Information is copyright its respective author. All material is available from the Linux Kernel Source distributed under a GPL License. This page is provided as a free service by mjmwired.net.