Based on kernel version 5.17
. Page generated on 2022-03-28 08:42 EST
.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 | Qualcomm's USB HS PHY PROPERTIES - compatible: Usage: required Value type: <string> Definition: Should contain "qcom,usb-hs-phy" and more specifically one of the following: "qcom,usb-hs-phy-apq8064" "qcom,usb-hs-phy-msm8916" "qcom,usb-hs-phy-msm8974" - #phy-cells: Usage: required Value type: <u32> Definition: Should contain 0 - clocks: Usage: required Value type: <prop-encoded-array> Definition: Should contain clock specifier for the reference and sleep clocks - clock-names: Usage: required Value type: <stringlist> Definition: Should contain "ref" and "sleep" for the reference and sleep clocks respectively - resets: Usage: required Value type: <prop-encoded-array> Definition: Should contain the phy and POR resets - reset-names: Usage: required Value type: <stringlist> Definition: Should contain "phy" and "por" for the phy and POR resets respectively - v3p3-supply: Usage: required Value type: <phandle> Definition: Should contain a reference to the 3.3V supply - v1p8-supply: Usage: required Value type: <phandle> Definition: Should contain a reference to the 1.8V supply - extcon: Usage: optional Value type: <prop-encoded-array> Definition: Should contain the vbus extcon - qcom,init-seq: Usage: optional Value type: <u8 array> Definition: Should contain a sequence of ULPI address and value pairs to program into the ULPI_EXT_VENDOR_SPECIFIC area. This is related to Device Mode Eye Diagram test. The addresses are offsets from the ULPI_EXT_VENDOR_SPECIFIC address, for example, <0x1 0x53> would mean "write the value 0x53 to address 0x81". EXAMPLE otg: usb-controller { ulpi { phy { compatible = "qcom,usb-hs-phy-msm8974", "qcom,usb-hs-phy"; #phy-cells = <0>; clocks = <&xo_board>, <&gcc GCC_USB2A_PHY_SLEEP_CLK>; clock-names = "ref", "sleep"; resets = <&gcc GCC_USB2A_PHY_BCR>, <&otg 0>; reset-names = "phy", "por"; v3p3-supply = <&pm8941_l24>; v1p8-supply = <&pm8941_l6>; extcon = <&smbb>; qcom,init-seq = /bits/ 8 <0x1 0x63>; }; }; }; |