# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
%YAML 1.2
---
$id: http://devicetree.org/schemas/net/cdns,macb.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#

title: Cadence MACB/GEM Ethernet controller

maintainers:
  - Nicolas Ferre <nicolas.ferre@microchip.com>
  - Claudiu Beznea <claudiu.beznea@microchip.com>

properties:
  compatible:
    oneOf:
      - items:
          - enum:
              - cdns,at91rm9200-emac  # Atmel at91rm9200 SoC
          - const: cdns,emac          # Generic

      - items:
          - enum:
              - cdns,zynq-gem         # Xilinx Zynq-7xxx SoC
              - cdns,zynqmp-gem       # Xilinx Zynq Ultrascale+ MPSoC
          - const: cdns,gem           # Generic
        deprecated: true

      - items:
          - enum:
              - xlnx,versal-gem       # Xilinx Versal
              - xlnx,zynq-gem         # Xilinx Zynq-7xxx SoC
              - xlnx,zynqmp-gem       # Xilinx Zynq Ultrascale+ MPSoC
          - const: cdns,gem           # Generic

      - items:
          - enum:
              - cdns,at91sam9260-macb # Atmel at91sam9 SoCs
              - cdns,sam9x60-macb     # Microchip sam9x60 SoC
              - microchip,mpfs-macb   # Microchip PolarFire SoC
          - const: cdns,macb          # Generic

      - items:
          - enum:
              - atmel,sama5d3-macb    # 10/100Mbit IP on Atmel sama5d3 SoCs
          - enum:
              - cdns,at91sam9260-macb # Atmel at91sam9 SoCs.
          - const: cdns,macb          # Generic

      - enum:
          - atmel,sama5d29-gem        # GEM XL IP (10/100) on Atmel sama5d29 SoCs
          - atmel,sama5d2-gem         # GEM IP (10/100) on Atmel sama5d2 SoCs
          - atmel,sama5d3-gem         # Gigabit IP on Atmel sama5d3 SoCs
          - atmel,sama5d4-gem         # GEM IP (10/100) on Atmel sama5d4 SoCs
          - cdns,np4-macb             # NP4 SoC devices
          - microchip,sama7g5-emac    # Microchip SAMA7G5 ethernet interface
          - microchip,sama7g5-gem     # Microchip SAMA7G5 gigabit ethernet interface
          - sifive,fu540-c000-gem     # SiFive FU540-C000 SoC
          - cdns,emac                 # Generic
          - cdns,gem                  # Generic
          - cdns,macb                 # Generic

  reg:
    minItems: 1
    items:
      - description: Basic register set
      - description: GEMGXL Management block registers on SiFive FU540-C000 SoC

  interrupts:
    minItems: 1
    maxItems: 8
    description: One interrupt per available hardware queue

  clocks:
    minItems: 1
    maxItems: 5

  clock-names:
    minItems: 1
    items:
      - enum: [ ether_clk, hclk, pclk ]
      - enum: [ hclk, pclk ]
      - const: tx_clk
      - enum: [ rx_clk, tsu_clk ]
      - const: tsu_clk

  local-mac-address: true

  phy-mode: true

  phy-handle: true

  phys:
    maxItems: 1

  resets:
    maxItems: 1
    description:
      Recommended with ZynqMP, specify reset control for this
      controller instance with zynqmp-reset driver.

  reset-names:
    maxItems: 1

  fixed-link: true

  iommus:
    maxItems: 1

  power-domains:
    maxItems: 1

  cdns,rx-watermark:
    $ref: /schemas/types.yaml#/definitions/uint32
    description:
      When the receive partial store and forward mode is activated,
      the receiver will only begin to forward the packet to the external
      AHB or AXI slave when enough packet data is stored in the SRAM packet buffer.
      rx-watermark corresponds to the number of SRAM buffer locations,
      that need to be filled, before the forwarding process is activated.
      Width of the SRAM is platform dependent, and can be 4, 8 or 16 bytes.
 
  '#address-cells':
    const: 1
 
  '#size-cells':
    const: 0

  mdio:
    type: object
    description:
      Node containing PHY children. If this node is not present, then PHYs will
      be direct children.

patternProperties:
  "^ethernet-phy@[0-9a-f]$":
    type: object
    $ref: ethernet-phy.yaml#

    properties:
      reset-gpios: true

      magic-packet:
        type: boolean
        description:
          Indicates that the hardware supports waking up via magic packet.

    unevaluatedProperties: false

required:
  - compatible
  - reg
  - interrupts
  - clocks
  - clock-names
  - phy-mode

allOf:
  - $ref: ethernet-controller.yaml#

  - if:
      not:
        properties:
          compatible:
            contains:
              const: sifive,fu540-c000-gem
    then:
      properties:
        reg:
          maxItems: 1

unevaluatedProperties: false

examples:
  - |
    macb0: ethernet@fffc4000 {
            compatible = "cdns,macb";
            reg = <0xfffc4000 0x4000>;
            interrupts = <21>;
            cdns,rx-watermark = <0x44>;
            phy-mode = "rmii";
            local-mac-address = [3a 0e 03 04 05 06];
            clock-names = "pclk", "hclk", "tx_clk";
            clocks = <&clkc 30>, <&clkc 30>, <&clkc 13>;
            #address-cells = <1>;
            #size-cells = <0>;
 
            ethernet-phy@1 {
                    reg = <0x1>;
                    reset-gpios = <&pioE 6 1>;
            };
    };
 
  - |
    #include <dt-bindings/clock/xlnx-zynqmp-clk.h>
    #include <dt-bindings/power/xlnx-zynqmp-power.h>
    #include <dt-bindings/reset/xlnx-zynqmp-resets.h>
    #include <dt-bindings/phy/phy.h>
 
    bus {
            #address-cells = <2>;
            #size-cells = <2>;
            gem1: ethernet@ff0c0000 {
                    compatible = "xlnx,zynqmp-gem", "cdns,gem";
                    interrupt-parent = <&gic>;
                    interrupts = <0 59 4>, <0 59 4>;
                    reg = <0x0 0xff0c0000 0x0 0x1000>;
                    clocks = <&zynqmp_clk LPD_LSBUS>, <&zynqmp_clk GEM1_REF>,
                             <&zynqmp_clk GEM1_TX>, <&zynqmp_clk GEM1_RX>,
                             <&zynqmp_clk GEM_TSU>;
                    clock-names = "pclk", "hclk", "tx_clk", "rx_clk", "tsu_clk";
                    #address-cells = <1>;
                    #size-cells = <0>;
                    iommus = <&smmu 0x875>;
                    power-domains = <&zynqmp_firmware PD_ETH_1>;
                    resets = <&zynqmp_reset ZYNQMP_RESET_GEM1>;
                    reset-names = "gem1_rst";
                    phy-mode = "sgmii";
                    phys = <&psgtr 1 PHY_TYPE_SGMII 1 1>;
                    fixed-link {
                            speed = <1000>;
                            full-duplex;
                            pause;
                    };
            };
    };